FARWEST PAINT PRODUCT INFORMATION

Exterior Finish Coatings

#692 Woodtone Semi-Transparent Stain (Interior/Exterior)

COLOR(S): Tints.

PRODUCT TYPE: High Quality Exterior Alkyd.

DESCRIPTION: A soft, flat finish for all unfinished paneling, wood millwork, furniture, floors, plus new siding and trim. Available in a wide selection of colors to choose from.

Intended Use: For new siding and trim, wood millwork, unfinished paneling, furniture, or floors.

PHYSICAL CHARACTERISTICS

VISCOSITY: 14" (FORD 4)

DRY TO TOUCH: 1 hour

WEIGHT SOLIDS: 42-44%

TACK FREE: 8 hours

VOLUME SOLIDS: 27-29%

TIME TO RECOAT: Overnight

WEIGHT PER GALLON: 8.40 lbs. per gal.

DRY HARD: 18 hours

V.O.C.: 577 grams per liter

COLOR RANGE: Tints

FLASH POINT: 105° F.

PACKAGING: 1 or 5 gallon containers

BATCH: Stock

PRACTICAL COVERAGE: 300-400 square feet per gallon depending on the porosity of the surface to be coated.

SURFACE PREPARATION: Surface must be dry, clean and free from all foreign agents and properly prepared. Before starting to stain, try a small sample to determine how heavy to apply stain to get desired color tone. Wipe off any excess not penetrated into wood with a soft cloth.

APPLICATION: When staining interior millwork, wipe stain on with a lint-free cloth applying a liberal amount; then wipe clean with a dry cloth bringing out the highlights of the natural wood grain. For best results, allow the stain to dry a minimum of eight hours or overnight before applying a clear finish or sealer. For interior surfaces: Finish with Farwest #677 Semi-Gloss or #675 High-Gloss Polyurethane Finish. Use the same finishing schedule for exterior door and door trim. On exterior siding: Where a stained semi-transparent finish is desired, apply one or two liberal coats of desired colored stain. When coating exterior siding in moist, humid climates where extra mildew and mold protection is required, the siding should be sealed with Farwest #641 Clear Wood Seal before applying stain and clear finishes (no other finish is required). When a gloss finish is needed: Apply one coat of stain and one or two coats of Farwest #690 Clear Log Oil. Exterior surfaces and rough sawn wood may be stained with a brush, roller or by spray.

THINNING: Thin if necessary with Farwest #602 Mineral Spirits.

CLEAN-UP: Tools and equipment may be cleaned with Farwest #602 Mineral Spirits.

LIMITED WARRANTY. To the best of our knowledge, the technical data presented above is true and accurate at the date of issuance and subject to change without prior notice. Farwest Paint Manufacturing Co. guarantees its products to conform to its standards of quality control. Liability is limited to replacement of product. No other warranty or guarantee of any kind is made by Farwest Paint Manufacturing, implied or otherwise.